Danby DAC150EB1GDB Guide D'utilisation Et Soins De Propriètaire page 15

1
Remove Chassis (cont'd)
5) Gently lift front off unit and place to one side (See. Fig. D)
6) Remove shipping screws from top of unit and also on the side by the base if installed.
7) Hold the cabinet while pulling on the base handle, and carefully remove the chassis from the cabinet.
8) Add two foam inserts to holes in top of cabinet where shipping screws were removed from (See Fig. E).
9) Your unit may come with internal packaging. This packaging must be removed prior to installing the air
conditioner back into the cabinet.
2
Install Top Angle and Side Bracket
1) Attach foam gasket to top angle above holes as shown in Fig. F.
2) Install top angle and side retainers to cabinet as show in Fig. F.
3
Assemble Window Filler Panels (see Fig. G)
1) Place cabinet on floor, a bench, or a table.
2) Slide the window filler panel frame into the top (L shaped) and
bottom (U shaped) channels. The shutters are identified (on the
frame) as left and right.
3) Insert washer head locking screws (2) into holes in top leg of filler
panel frame. Do not totally tighten. Allow leg to slide freely. Screws
will be tightened later.
Plastic
Frame
Fig.G
4
Install Top Angle and Side Bracket
1) Open window and mark center of window sill.
2) Place cabinet in window with lower "U" channel of cabinet firmly
seated over window sill. Bring window down temporarily behind top
"L" bracket to hold cabinet in place.
3) Shift cabinet left or right as needed to line up center of cabinet on
center line marked on window sill.
4) Fasten cabinet to window sill with 2 screws (you may want to pre-drill
holes).
5) Add bottom rail seal over screws to window sill. See Fig. H
INSTALLATION INSTRUCTIONS
Fig. D
Window Filler
Panel
"L" Shaped
mounting bracket
"U" Shaped
Channel
Foam Inserts
Fig. E
Fig. H
13
Fig. F
Bottom
Rail Seal
3/4in.(19mm) Long
Hex-head Screw