Danby DAC150EB1GDB Guide D'utilisation Et Soins De Propriètaire page 14

LOCATION
A) This room air conditioner is designed to fit easily into a
single or double hung window. However, since window
designs vary, it may be necessary to make some
modifications for safe, proper installation.
B) Make sure window and frame are structurally sound
and free from dry and rotted wood.
C) For maximum efficiency, install the air conditioner on a
side of the house or building which favours more shade
than sunlight. If the unit is in direct sunlight, it is
advisable to provide an awning over the unit.
D) Provide sufficient clearance around the cabinet to allow
for ample air circulation through the unit (See Fig. 2).
The rear of the unit should be outdoors and not in a
garage nor inside a building. Keep unit as far away as
possible from obstacles/obstructions and at least 30"
above the floor or ground. Curtains and other objects
within a room should be prevented from blocking the air
flow.
E) Be certain the proper electrical outlet is within reach of
the installation. Use only a single outlet circuit rated at
15 amps. All wiring should be in accordance with local
and national electrical codes.
F) DO NOT install unit where leakage of combustible gas
is suspected. Your air conditioner may fail to operate in
air containing oils (including machine oils), sulfide gas,
near hot springs, etc.
NOTE: Your unit is designed to evaporate condensation
under normal conditions. However, under extreme humidity
conditions, excess condensation may cause basepan to
overflow to the outside. The unit should be installed where
condensation run-off cannot drip on pedestrians or neigh-
boring properties.
WINDOW MOUNTING
1
Remove Chassis:
1) Pull down front panel and remove filter (See Fig. A)
2) Lift front panel upwards and place to one side.
3) Locate the four (4) front screws and remove (Fig B).
These screws will be needed to re-install the front later.
4) Pry away the front panel from cabinet sides as shown in
Fig.C.
INSTALLATION INSTRUCTIONS
Fig. B
Fig. 2
20"
Min
Side
Obstruction
Ground
NOTE: Save the shipping carton and packing materials for
future storage or transportation. From the carton, remove the
plastic bag containing the installation hardware kit neces-
sary for the installation of your air conditioner. Please
check the contents of hardware kit against the correspon-
ding model check list, prior to installation of the unit.
See Fig. 1.
NOTE: Your Room Air Conditioner is designed for easy
installation in a single or double-hung window. This unit is
NOT designed for vertical (slider type) windows and/or
through-the-wall applications.
CAUTION
Because the compressor is located on the controls
side of the unit (left side), this side will be heavier and
more awkward to manipulate. Inadequate support on
control side of the unit can result in personal injury
and damage to your unit and property. Therefore, it is
recommended that you have someone assist you dur-
ing the installation of this unit.
Fig. A
Fig. C
12
Awning
12" Min
20"
Min
Fence,
30"
wall, or
Min
other
obstacle