Using The Attachments - Kenwood FPP210 Série Manuel D'utilisation

using the attachments

Refer to recommended speed chart for each attachment.
knife blade
The knife blade is the most versatile of all the attachments.
The length of the processing time will determine the texture
achieved. For coarser textures use the pulse control.
Use the knife blade for cake and pastry making, chopping
raw and cooked meat, vegetables, nuts, pate, dips,
pureeing soups and to also make crumbs from biscuits and
bread.
It can also be used for yeasted dough mixes if the dough
tool is not supplied.
hints
Cut food such as meat, bread, vegetables into cubes
●
approximately 2cm/3/4in before processing.
Biscuits should be broken into pieces and added down the
●
feed tube whilst the machine is running.
When making pastry use fat straight from the fridge cut into
●
2cm/3/4in.cubes.
Take care not to over-process.
●
dough tool
(if supplied)
Use for yeasted dough mixes.
Place the dry ingredients in the bowl and add the liquid
●
down the feed tube whilst the machine is running. Process
until a smooth elastic ball of dough is formed this will take
60 secs.
Re-knead by hand only. Re-kneading in the bowl is not
●
recommended as it may cause the processor to become
unstable.
emulsifying tool
Use for light mixtures only eg cream, mayonnaise.
hints
Ensure the bowl and tool are clean and free from grease
●
before use.
slicing/grating disc
To use the disc.
reversible slicing/grating disc
Use the grating side for cheese, carrots, potatoes and foods
of a similar texture.
Use the slicing side for cheese, carrots, potatoes, cabbage,
cucumber, courgette, beetroot and onions.
safety
Never remove the lid until the cutting disc has
●
completely stopped.
Handle the cutting discs with care - they are
●
extremely sharp
to use the cutting discs
1 Fit the bowl onto the power unit, add the detachable drive
shaft .
2 Holding by the centre grip, place the disc onto the drive shaft
with the appropriate side uppermost.
3 Fit the lid.
4 Put the food in the feed tube.
5 Switch on and push down evenly with the pusher - never
put your fingers in the feed tube.
hints
Use fresh ingredients
●
Don't cut food too small. Fill the width of the feed tube fairly
●
full. This prevents the food from slipping sideways during
processing.
Food placed upright comes out shorter than food placed
●
horizontal.
There will always be a small amount of waste on the disc or
●
in the bowl after processing.
citrus juicer
Use the citrus juicer to squeeze the juice from citrus fruits
(eg oranges, lemons, limes and grapefruits).
cone
sieve
to use the citrus juicer
1 Fit the bowl onto the power unit, add the detachable drive
shaft.
2 Fit the sieve into the bowl - ensuring the sieve handle is
locked into position directly over the bowl handle.
3 Place the cone over the drive shaft turning until it drops all
the way down.
4 Cut the fruit in half. Then switch on and press the fruit onto
the cone.
The citrus juicer will not operate if the sieve is
●
not locked correctly.
For best results store and juice the fruit at room temperature
●
and hand roll on a worktop before juicing.
To help with juice extraction move the fruit from side to side
●
when juicing.
When juicing large quantities, empty the strainer regularly to
●
prevent the build up of pulp and seeds.
5
(if supplied)