Trial Operation Check - Toshiba TCS-NET Manuel D'installation

TCS-NET GSM Phone Control Interface
7

Trial Operation Check

Insert the plug of the AC adapter firmly into a power outlet as far as it will go. Improper connection may cause electric
shock or fire due to accumulated dust.
When the TCB-IFGSM1E is connected to an air conditioner that uses CN61, turn on the air conditioner. When the
TCB-IFGSM1E is connected to an air conditioner that uses an HA connector, connect an external power supply
unit to the DC jack and supply power to the TCB-IFGSM1E. When PIN code and PUK code for the modem are
given from the telephone service company and they must be set, set them using the following procedure.
PIN Code / PUK Code Setting Procedures
Setting PIN code
Press and release the reset switch SW4 while pressing the set switch SW3, wait for at least 10 seconds, and then
release SW3. Then the TCB-IFGSM1E enters the PIN code read mode. Specify the lowest digit of PIN with the PIN
code set switch SW2, and then press SW3 for less than 10 seconds. Then set the second lowest digit of PIN and
press SW2 for less than 10 seconds. Repeat this operation to enter the specified PIN code. After all the digits have
been set, press SW3 for at least 10 seconds to complete the PIN setting procedure.
Example) If the PIN is 45678, specify 8, 7, 6, 5, and 4 in this order.
Setting PUK code
To set a PUK code following the PIN code setting, press SW3 for less than 10 seconds within 10 seconds upon
completion of the PIN setting. The TCB-IFGSM1E enters the PUK code setting mode. Specify the lowest digit of
PUK code with SW2, and then press SW3 for less than 10 seconds to enter the lowest digit. Repeat this operation
until the 8-digit PUK code is completely read.
Example) If the PUK is 34724569, specify 9, 6, 5, 4, 2, 7, 4, and 3 in this order.
PIN code is a 4-digit to 8-digit number, and PUK code is an 8-digit number. Therefore, the TCB-IFGSM1E
automatically returns from the PUK code setting mode after eight numbers have been given in the PUK code
setting, but remains in the waiting state until 8 digits of the PUK code have been completely read.
Modem Emulator Setting and Operation Check
Setting the modem emulator
Install the modem emulator software for this system to the PC (with RS-232C communication function) beforehand.
For computers which do not have serial port, PC Card or USB to RS-232C converter can be used to arrange an
RS-232C port. Connect the RS-232C D-sub connector of the PC to the D-sub connector of the TCB-IFGSM1E with
an RS-232C cross cable.
Set the communication configuration of the PC to 9600bps, non parity, 8 bits, 1 stop bit with an appropriate
communication port number.
Start the modem emulator software. The following screen appears.
• Set the serial port number to the number set on the PC.
• From the READY, SIM PIN, and PUK radio buttons, choose READY when no PIN is set.
• From the READY, SIM PIN, and PUK radio buttons, choose SIM PIN when a PIN is set.
• Enter the mobile phone number to be used for the test in the TEL textbox.
The number set here is the number the modem will recognise and the GSM phone number used for this test. The
number must be set as <GSM phone number> or <"+" + "Country code" + "GSM phone number">. For the details,
ask your mobile network operator.
CAUTION
– 13 –
Installation Manual
EN
12-EN