Eliminating Minor Faults Yourself - Junker JCGB Série Mode D'emploi

en

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
The light does not work.
There is a thick layer of frost
in the freezer compartment.
Floor of the refrigerator
compartment is wet.
The temperature in
the refrigerator
compartment is too cold.
The refrigerating unit
is switching on more
frequently and for longer.
34
Possible cause
The bulb is defective.
Light switch is jammed.
The condensation channels
or drainage hole are blocked.
Freezer compartment door is
open.
Too much food was placed in
the freezer compartment at
once.
Temperature controller has
been set too high.
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
Remedial action
Replace bulb. Fig. '/B
1. Switch the appliance off.
2. Pull out mains plug or switch off fuse.
3. Slide cover forwards and remove.
4. Change the bulb.
(Replacement bulb: 220-240 V a.c., E14
bulb holder, see defective bulb for
wattage.)
Check whether the light switch can move.
Fig. '/A
Defrosting the freezer compartment (see
chapter Defrosting). Always ensure that the
freezer compartment door is closed properly.
Clean the condensation channels
and the drainage hole. See chapter Cleaning
the appliance. Fig. %
Close the freezer compartment door. The
freezer compartment door engages audibly.
Do not exceed max. freezing capacity.
Set temperature controller lower.
Do not open the appliance unnecessarily.
Remove obstacles.
Do not exceed max. freezing capacity.