How To Disassemble - Hkoenig HSX16 Manuel D'utilisation

How to disassemble

Before cleaning this product, be sure to shut down the switch to disconnect the power
1.
supply.
Clean this product after using it.
2.
The main unit cannot be washed with water, and must be cleaned with twisted wet cloth
3.
instead.
Before storing it, make sure this product is clean and dry.
4.
Disassemble this product to wash the components by following the steps below:
5.
Ÿ
Clean the food and cut it into pieces small sufficiently to
pass through the feeding chute, and place them onto the
9
hopper.
Any hard core, seed, skin or shell shall be removed in
•
advance.
Froward:start to work
•
Off: power-off,stop the work
•
10
Reverse: rotate in reverse direction to solve food stuck
•
problem
Load the food material in through the inlet and push them in
with propelling rod.
Proper amount of force shall be used to push the food
•
material in, not excessive but sufficient to have it cut off
11
exactly.
(Do not put your finger or any other object into the inlet!
If the residue/juice container is full, disconnect the power
supply and clear it up before restart.）
1 First lift up the push rod and hopper
Lift up the locking ring, pull out the feeding
2
chute easily