Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Power
Touch the
key to switch on the device. The
display will illuminate and operate in cooling mode
at low wind speed by default. Press again to switch
off in stand-by mode.
Note: Make sure the stand-by switch is in |
position in order to switch on the device. If the
stand-by switch is in O position, all buttons are
disabled.
Change speed
Press the
key to increase or decrease the wind
speed in the following sequence: Low (1) > Medium
(2) > High (3) > Strong (4). Default setting is Low
(1) speed. The icons of the LED display will change
accordingly.
Timer
Timer is deactivated when using the device for the
first time. Press the
key to activate the timer
mode. You can switch the timer in the following
order: 1h > 2h > 4h > 8h. The corresponding
indicators will illuminate on the display. You can
also read the timer count down on the display (e.g.
if 4h timer is activated, the display will change to 2h
after 2h, and so on). After the timer is completed,
the device will switch to stand-by mode.
8
Oscillation
Oscillation is deactivated when using the device for
the first time. By pressing the
key,
the device will automatically oscillate horizontally
up to 80 degrees. The indicator on the display will
illuminate accordingly. The verticale angle can be
adjusted manually in 4 positions, up to 90⁰.
Heating mode
Heating mode is deactivated when using the
device for the first time. Press the
key to turn
on the heating mode. Once pressed, the heating
mode will start in Medium (2) speed mode and
the corresponding indicator on the display will
illuminate. Pressing again will increase the heating
power to High (3) speed mode.
Note: It's not possible to manually adjust the
speed of the heating mode. When pressing the
key, the device will return in cooling mode.
Pressing this key again will activate ECO mode.
When the room temperature is below 18⁰C,
the High (3) speed heating mode will turn on
automatically. When the room temperature
is between 18⁰C and 22⁰C, the Low (2) speed
heating mode will be activated. When the room
temperature is above 22⁰C, the heating mode
will deactivate and the fan will stop working. To
continue in cooling mode, switch on the fan by
pressing the
button. Pressing this key for a 4th
time will return to cooling mode.
Natural wind & night mode
Night mode is deactivated when using the device
for the first time. Press the
key to activate
natural wind & night mode. The corresponding
indicator will illuminate on the display. Press again
to deactivate this mode.
Natural wind & night mode in HI speed
6
12
Hi
6
6
Mid
6
Low
3
Natural wind & night mode in MID speed
Hi
6
12
6
Mid
6
6
Low
3
Natural wind & night mode in LOW speed
Hi
6
6
Mid
6
6
12
Low
3
Note: The natural wind & night mode cannot be
used in combination with the heating mode. Once
natural wind & night mode is activated, pressing the
heating mode key will automatically deactivate the
natural wind & night mode.
The natural wind & night mode works according to
the below programming:
6
6
6
6
12
6
6
3
Time (Sec)
Time=90s
6
6
6
6
6
6
6
6
3
Time (Sec)
Time=90s
6
6
6
15
6
3
3
Time (Sec)
Time=90s
9
Publicité
Chapitres
Table des Matières
