Troubleshooting Guide; Fault Correction - Scheppach LB2600E Traduction Du Manuel D'origine

GB

15. Troubleshooting guide

Problem Possible cause
Mains voltage is not present
Defective on/off switch
Device does not start
Worn carbon brushes
Defective motor
Blowing/suction pipe is not completely fitted Install a two-part blowing/suction pipe
Damaged power cable
Device works with
Internal loose connection
interruptions
Defective on/off switch
Collection bag is full
Collection bag is dirty
Low suction capacity or
Selector switch in incorrect
suction not present
position
Device clogged up or blocked by foreign
bodies
Selector switch in incorrect
position
Small or missing blowing
power Airstream regulator in
incorrect position
Device works with Foreign body blocks impeller
interruptions wheel
20 І 64

Fault correction

Check plug socket, cable, line, plug and fuse,
where appropriate, repair through electrical
specialist
Repair through customer service
Check cable; where appropriate, replace
Repair through customer service
Empty collection bag
Clean collection bag
Set selector switch to the suction symbol
Remove plug or blockages (see chapter Cleaning
and Maintenance)
Set selector switch to the blowing symbol
Rotate airstream regulator to high position
Remove blockage