Disposal Of The Packaging; Electrical Connection - Hkoenig KREP29 Manuel D'utilisation

Unpacking
Remove the device out of the carton, remove the packaging material, shovel and measuring
container.

Disposal of the packaging

The packaging protects the device against damages during transit. The packag ing materials
selected in accordance with environmentally compatible and recycling-related points of view and
can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer
required to «Green Dot» recycling collection points for disposal.
Please note
• If possible, keep the original packaging for the device for the duration of the guarantee
of the device, in order that the device can be re-packaged properly in the event of a guarantee
claim.
Setup location requirements
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the follow ing prerequisites:
• Place the device on a firm, flat, level and heat-resistant surface with sufficient loadbearing
capacity for the device and its contents.
• Choose the setup location in such a way that children cannot reach any hot surfaces on the
device.
• The device is not intended to be installed in a wall or a built-in cupboard.
• Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
• Do not place the device near a gas or electric cooker or an oven.
• The device requires an adequate flow of air in order to operate correctly. Leave a clearance of
20 cm all around the device.
• Do not cover up any openings on the device and do not block these off.
• The electrical socket must be easily accessible so that the power lead can be disconnected
easily, in the case of an emergency .
• The device and power cord should not come in contact with the hot surface. The device could
be damaged.
• The installation and assembly of this device in non-stationary setup locations must be carried
out by specialist companies/ electricians , provided they guarantee the prerequisites for the safe
use of this device.

Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on the
rating plate with those of your electrical network. This data must agree in order that no damages
occur in the device. If in doubt, ask your qualified electrician.
are
period