Lindy 39336 Mode D'emploi page 5

User Manual
Installation
Please install your KVM Switch Pro USB Audio as described below:
Step 1. Connect the power supply to the KVM switch before you connect any other cables.
Step 2. Connect your keyboard & mouse to the USB ports and your monitor to the monitor port
labelled CONSOLE on the KVM switch – Please regard the maximum monitor cable lengths
as mentioned in this manual and in the product descriptions on the LINDY website. Connect
your speakers and microphone if required.
Step 3. Connect your computers using high quality cables of appropriate length – The maximum
distance for USB 2.0 is 5m and 3m for USB 3.0. If you require a longer distance then please
use a USB Active Extension Cable. Please also regard the maximum video cable lengths as
mentioned.
Step 4. Turn on the power to all devices and computers.
Step 5. Your computer should now boot and detect the newly installed hardware. Windows OS
will detect and install multiple USB device drivers. Please wait until this procedure has finally
completed to ensure correct operation.
A Mac system may not identify PC keyboards at the first boot and may show an identification
menu; please follow the on-screen information. In some cases, it may be necessary to unplug the
keyboard & mouse and re-connect to allow the USB ports to re-detect.
Windows OS includes all relevant USB device drivers so no additional drivers are required to be
installed.
KVM switching options
Computer port selection may be made by any of the following:
o Front panel push buttons on the switch
o Keyboard Hotkey – configurable by the user
Front panel push buttons with white/red LED indicators
Press the front push button to select the appropriate port/computer. During the switching process
a white LED behind the switch button will flash. The LED will remain on when switching is
completed and the connections are established.
Depending on the configuration, only the KVM ports (USB keyboard, mouse and monitor) or KVM
and USB 2.0 hub and/or Audio ports are switched. To learn more about these options, please
refer to the table on the next page.
The white port LEDs refer to the KVM section status, the red port LEDs refer to the USB hub
selection status and shows the port/computer currently selected.
Keyboard Hotkey Switching
The KVM switch may also be conveniently switched and configured using keyboard hotkeys. This
process is invoked by pressing a universal hotkey on the keyboard twice within 2 seconds. The
factory default setting for this universal hotkey is the SCROLL LOCK button. The KVM switch can
be reconfigured to use a different hotkey from the following list: NUM LOCK, or CAPS LOCK, or
F12 or Escape (ESC) key.
Press the universal hotkey twice to invoke the switching function – the KVM switch will confirm
this with a short beep signal. Depending on the next key you press you can select any of the
available switching or configuration functions of the KVM switch. Please refer to the following
table for the available options.
- 5 -
English