KED POP Mode D'emploi page 15

5. Firm fit
You can check that your helmet is sitting firmly by lightly shak-
ing your head while the chinstrap is undone. The helmet should
not move about. An optimal fit is necessary for the helmet to
fully achieve its safety function.
6. Adjusting the chinstrap
a)
Close the snap-in clip (see illustration 3.1). Slide the strap
tensioner (see illustration 4) so that the front and rear strap
come together below the ear, and centre the snap lock below
the chin. If the straps are not tight and closely fitted, you will
need to re-tighten the excess length of the strap using the snap
lock. To do so, open the locking plate on the male part and
adjust the strap length (see illustration 3.2) Repeat this process
until the strap system is tight and closely fitted. Firmly lock the
locking plate again at the snap lock. The snap lock must not lie
directly on the chin.
b)
The chinstrap should fit tightly but not impair your ability to
breathe or swallow.
7. Extras
7.1 Light
The K-FIT adjustment system is equipped with a flashing light.
You can turn the flashing light on and off by pressing it (see
illustration 2.1). The following functions are available:
Press once for a continuous light,
press twice for a flashing light,
press three times to turn off the light.
Changing the battery: use a slender Philips screwdriver to open
the compartment (see illustration 6), remove the circuit board
and replace the battery).
8. Care, cleaning and storage
The comfort padding can be cleaned using a damp cloth. Use
a mild soap solution or heavily diluted delicate detergent as
the cleaning agent. The comfort padding and straps should be
dried at room temperature.
The helmet shell should be cleaned using lukewarm water and
a mild soap solution. Do not use any solvents, e.g. thinner or
similar.
15