Installation Instructions; Temperature Selection; Defrosting Your Appliance - Danby DCFM110B1WDB Guide D'utilisation

Installation Instructions

1. Select a place with a strong, level fl oor.
2. Allow a clearance of 12.7 cms (5 inches) between the back/sides and any adjacent wall. Please allow adequate
clearances between the freezer lid and ceiling.
Place the appliance fi rmly on a solid base. Some appliances have adjustable feet on the front side; use them to level the
appliance (some models only).
NOTE: This appliance is intended for FREE-STANDING INSTALLATION ONLY and is NOT intended to be built-in.
This appliance is approved for INDOOR USE ONLY and is NOT intended for outdoor operation.
Handle Installation (some models only)
1. Using the screws provided, you will need to remove them from the front of the unit, screw the handle base onto the lid.
2. Replace the handle cover.
Screws
Operating Instructions

TEMPERATURE SELECTION

Once the unit is plugged in, set the temperaturewe between MIN and
MAX. MIN is the warmest setting, MAX is the coldest setting. To set the
temperature, press the "SET" button
desired temperature position. Note: When the green indicator light is il-
luminated, the compressor is working. When it is not illuminated, the unit
still has power, however the compressor is not working.
If you have placed a large quantity of food in your unit and want the
compressor to run continuously for 52 hours, press "SET" until "SUPER"
freezing is activated.
In the event of a power failure, the unit will return to its previous setting
when power is restored. Note: When there is an error in the temperature
sensor, the temperature indicator bar will fl ash every second from left to
right.

DEFROSTING YOUR APPLIANCE

For proper defrosting and cleaning, the following method is recommended:
a) Unplug freezer.
b) Quickly remove all frozen food and store in baskets, cartons or other suitable containers.
Keep food well covered with blankets to avoid excessive temperature rise.
c) Remove the drain plug from the freezer, place a tray under the plug and rotate the drain dial
180 degrees, this will allow the water to drain out of the freezer compartment. Wipe the interior
of the freezer, replace the drain plug and resume freezer operation as normal.
Handle Base
until you have reached the
3
Handle Cover