Electrical Safety - Bosch ALS 2400 Notice Originale

OBJ_BUCH-2968-003.book Page 13 Wednesday, May 10, 2017 2:58 PM
Do not run over, crush or pull the

power supply cord or extension cord,
otherwise it may be damaged. Pro-
tect the cable from heat, oil and sharp
edges.
The extension lead must have a cross

section in accordance with the oper-
ating instructions and be protected
against splashed water. The connec-
tion must not be in water.

Electrical Safety

Warning! Switch off, remove
plug from mains before ad-
justing, cleaning or if cable is
cut, damaged or entangled.
 Motor Protector fitted! Motor fit-
ted with safety overload protec-
tion. If motor stops working, allow
a few minutes to cool, before re-
starting.

If a cord becomes damaged during
use, disconnect the supply cord
from the mains immediately. DO
NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use ap-
proved extension cables. Contact your
Bosch Service Centre for details.
For increased electrical safety use a Re-
sidual Current Device (RCD) with a trip-
ping current of not more than 30 mA.
Always check your RCD every time you
use it.
Bosch Power Tools
Keep the supply cables away from mov-
ing hazardous parts and avoid damage
to the cables; this can lead to contact
with live parts.
The connections (plugs and sockets)
should be kept dry and off the ground.
The supply cables must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cable on the product is
damaged, it must only be replaced by a
Bosch Service Centre.
Only use approved extension cables.
Extension cords, cables, leads, reels
should only be used if they comply with
EN 61242/IEC 61242 or
IEC 60884-2-7.
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
– Nominal Conductor Area of
2
1.25 mm oder 1.5 mm
– Maximum length of 30 m for a Cord
Extension Set or maximum length of
60 m for a Cable Reel with Residual
Current Device (RCD
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service Cen-
tre.
WARNING! Inadequate exten-
sion cables can be dangerous.
Extension cable, plug and
English | 13
2
F 016 L81 594 | (10.5.17)