Hatco Toast Qwik TQ-10 Série Manuel D'installation Et D'utilisation page 13

TQ-400, -800, and -1800 Series
Control Panel
The following are descriptions of the controls used to operate
the unit. All controls are located on the control panel on the
front of the unit.
Top Heat Control
The Top Heat ( ) Control adjusts the amount of heat to the top
heating element. The icon indicates that the heat will radiate
down from above.
Bottom Heat Control
The Bottom Heat ( ) Control adjusts the amount of heat to the
bottom heating element. The icon indicates that the heat will be
rise up from below.
Color Control
The Color Control adjusts the toasting color using the speed
of the conveyor. Turning the Color Control clockwise will toast
products to a darker color ( ). Turning the Color Control
counterclockwise will toast products to a lighter color ( ).
Power I/O (On/Off) Switch
The Power I/O (on/off) Switch controls power to the entire unit.
Bottom Heat Control
Form No. TQ2CEM1-1120
Top Heat Control
Color Control
Control Panel – TQ-400, -800, and -1800 Series
Operating TQ-400, -800, and -1800 Series
NOTE: TQ-400BA, -800BA, -800HBA, -1800BA, and -1800HBA
toasters are designed specifically for toasting one side
of a bread product, such as a bun or bagel. These
models toast with the cut side facing up.
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
2. Move the Power I/O (on/off) switch in the I (on) position.
3. Adjust the and/or
• For two sided toasting, turn the
Control clockwise to the highest setting.
• For one sided toasting, turn the
to the highest setting and turn the
counterclockwise to the lowest setting.
NOTE: When toasting a single-sided product such as a bun
or bagel, place the product with the cut side facing up.
Adjust the
of bread product and adjust the
as needed.
4. Turn the Color Control fully counterclockwise ( ) while the
toaster heats up.
NOTE: Allow approximately 15 to 20 minutes for a warm-up
period.
5. After warm-up period, toast two slices of bread product.
Adjust the Color Control if needed.
• If toasted bread product is too dark with the Color
Control set on the lightest setting, adjust the
or controls as needed. (Allow 15 to 20 minutes for
toaster to re-adjust to new setting before resuming
operation.)
• If toasted bread product is too light with the Color Control
set on the lightest setting, adjust the Color Control as
needed. (Allow 15 to 20 minutes for toaster to re-adjust
to new setting before resuming operation.)
NOTE: To toast moist products such as English Muffins, rye
bread or whole wheat, slow the conveyor by turning the
Color Control knob to a darker setting (clockwise).
IMPORTANT NOTE
If the warning light comes on, the unit may be overheating.
Turn off and unplug the unit. Refer to the "Daily Cleaning"
procedure to clean the cooling fan vents. If the unit does
not function properly after cleaning the cooling fan vents,
contact an Authorized Service Agent or Hatco for assistance.
Power Save Button
Warning Light
13
OPERATION
Controls.
Control and
Control clockwise
Control to a light setting, toast two slices
and/or
Power I/O (on/off) Switch
Control
Controls
and/