Dea 203RR Notice D'emploi Et Avertissements page 19

• When receiving a pulse from the transmitter, depending on your channel selection and linking, the
start or the pedestrian inputs are activated. In fact, by programming one of the working parameters it
is possible to choose, according to one's needs, which key of the memorized transmitters will activate
the start input and which one will activate the pedestrian input (see "Channel selection and linking on
the transmitter").
• While you memorize each transmitter the display shows a progressive number by which you will be
able to trace and, if necessary, delete each transmitter individually
Instructions
The control board is ready to receive instructions
Scroll down the parameters until you visualize P004
Confirm! The control board awaits a further confirmation
Confirm by pressing on the OK key for a few seconds! The procedure starts
Done! The transmitters memory has been deleted
Scroll down the parameters until you visualize "----". The control board awaits a
further confirmation
Scroll down the parameters until you visualize P005
Confirm! The receiver enters in memorization mode
The flashing light blinks!
Press on any key of the transmitter.
Memorization done! The flashing light goes out for 2 seconds
The display visualizes the number of the transm. just memorized (es. "r001")
The receiver reverts automatically to memorization mode
The flashing light blinks!
Memorize all necessary transmitters
Wait 10 seconds before quitting the memorization mode
The receiver will now receive all the memorized transmitters
Press simultaneously on key CH1 and CH2, or on the hidden key of a
transmitter already memorized
Scroll down the parameters until you visualize P006
Confirm! You can now select the transmitter
Scroll down the transmitter numbers until you reach the transmitter to be
deleted (eg. "r003")
Confirm the deletion by pressing the OK key for a few seconds
OK! The transmitter is deleted
You can now select the parameter
Scroll down the parameters until you visualize "----". The control board awaits
further instructions
Make sure that the receiver is set to receive the type of coding of the transmitter you wish to memorize: visualize and, if
1
necessary, update parameter n° 8 "Type of coding" (see "8.4 Personalization of working parameters "
Deletion of all transmitters
Memorization of transmitters
How to activate the memorization mode without
operating on the control board
How to search and delete a transmitter
Operating instructions and warnings
Function
1
1
Display
17
2 0 3 R R
R