Joannes ARN H 80 Notice Technique page 16

WARNINGS
Each generator is provided with a manufacture plate that can be found in the envelope with the boiler documents. The
plate lists:
•
Serial number or identification code;
•
Rated thermal output in kcal/h and in kW;
•
Furnace thermal output in kcal/h and in kW;
•
Types of fuels that can be used;
•
Max operating pressure.
A manufacture certificate is also provided which certifies the hydraulic test positive performance.
The installation must be performed in compliance with the regulations in force by professionally qualified personnel.
The term "professionally qualified personnel" means persons with specific technical skills in the sector of heating system
components.
Incorrect installation may cause damage to persons, animals or objects for which the manufacturer cannot be held respon-
sible.
At the first start up, all regulation and control devices positioned on the control panel should be checked for efficiency.
The guarantee shall be valid only upon compliance with the instruction given in this manual.
Our boilers have been built and tested in observance of EEC requirements and, as a consequence, CE-marked. EEC
directives are as follows:
•
Directive on Gas 90/396/EEC
•
Directive on Output 92/42/EEC
•
Directive on Electromagnetic Compatibility 89/336/EEC
•
Directive on Low Voltage 73/23/EEC.
IMPORTANT: This boiler has been designed to heat hot water at a temperature inferior to the boiling temperature at
atmospheric pressure and must be connected to a heating plant and/or a domestic hot water plant within the limits of its
performance and output.
- 1
-
GENERAL