Urmet 1092/225 Manuel D'utilisation page 30

SPEED
DELAY CNT
ATW FRAME
ENVIRONMENT
RETURN
This function is used to set indoor/outdoor operation, evaluate the light source and allow automatic white
balance.
The ENVIRONMENT option settings are: SHADE, AUTO, INDOOR, SUNNY.
PUSH
This option is used to set automatic white balance regardless of whether the picture is indoor/outdoor and
of the lighting conditions. The compensation may not be satisfactory because the control is conditioned by
the presence of intense colours in the frame.
USER 1
This function can be used to adjust white balance to preset values (3200ºK), without automatic tracking
even in variable lighting conditions.
USER 2
This function can be used to adjust white balance to preset values (5800ºK), without automatic tracking
even in variable lighting conditions.
The red and blue gain level can be adjusted for USER 1 and USER 2 (0 - 255).
MANUAL
Light temperature variation goes from 1500 K to 15000 K. White balance can be manually set to 64
different levels.
PUSH LOCK
PUSH LOCK mode is used to balance whites when the ENTER is pressed for fixed calibration and to
prevent further automatic adjustments.
HLC/BLC SUBMENU
Subjects will appear dark and hardly visible if lit by a strong light from the back. The BLC (Backlight)
function avoids this problem and provides good compensation.
The HLC (High Light Compensation or Eclipse function) must be used in excessive light conditions. It
allows a better balance of the brightness in dark and light zones to obtain a more detailed image.
The mask level can be adjusted for the HPC function.
DAY/NIGHT SUBMENU
The possible settings are: DAY(the camera is always in colour mode), NIGHT (the camera is always in
black and white mode, burst may be on or off), AUTO (the camera switches automatically to DAY/NIGHT
mode according to the established DAY
30
ATW SETUP
■■■█■■■■■ 127
■█■■■■■■■ 030
■■■■█■■■■ 128
SHADE
NIGHT or NIGHT DAY levels):
DS1092-171