Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.
Connect the terminals (+/-) of the RS-485 connector to a control keyboard (e. g. 1092/693) for camera
control and programming (all the parameters can be managed by a keyboard). Terminate the last
device of the line with a 120 ohm resistor. In case of long and/or underground cables, protect the
device with a dedicated filtering device (e.g. Urmet Ref, 1092/732).
7.
Power the camera.
Unscrew the screw on the bottom of the camera to access to the adjustment screws and to the OSD
menu button.
8.
Perform Zoom and Focus adjustment for the desired image as follows
Button for Focus and Zoom adjustment and
activation of the OSD menu
Tilt the button towards DOWN or UP to change the zoom of the image (Zoom 10X).
•
Tilt the button towards RIGHT or LEFT to adjust the focus of the image
•
Keep pressed the central button to access to the OSD menu
•
DS 1092-171
Unscrew to access to the
settings
21
Publicité
Table des Matières
