When The Work Is Done; Changing The Filter - Bosch Cosyy'y BGLS4 Série Mode D'emploi

When the work is done

17
Figure
a)Pull out the mains plug.
b)Briefly pull on the power cord and then release it (the
power cord retracts automatically).
18
Figure
To store/transport the appliance, you can use the
storage aid on the underside of the appliance.
a)Stand the appliance upright on its end.
b)Slide the hook on the floor tool into the recess on the
underside of the appliance.
Changing the filter
! Please note: Always switch off the appliance before
changing the filter.
Replacing the dust bag
19
Figure
If the dust bag change indicator in the lid is filled
completely when the floor tool is lifted from the floor
with the highest suction level selected, the dust bag
must be changed, even though it may not yet be full.
Even if the dust bag is not full, it may still need
changing, due to the type of dust which has been
vacuumed. First check that the nozzle, suction pipe
and flexible hose are not blocked, as this would also
lead to the dust bag change indicator being triggered.
The hand grip can easily be detached from the hose
to remove blockages.
20
Figure Opening the lid
a)Unlock the lid by pulling on the locking lever in the
direction of the arrow.
b)Open the lid in the direction of the arrow.
21
Figure
a)Close the dust bag by pulling on the locking tab.
b)Take out the dust bag.
c) Insert a new dust bag.
d)Push the dust bag fully into the holder.
! Please note: the lid will only close if a dust bag has
been inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly
by knocking out the dirt and rinsing.
22
Figure
Open the dust bag compartment lid.
a)Release the motor protection filter from the catch by
pulling it sideways, and pull it out in the direction of
the arrow.
b)Clean the motor protection filter by tapping out the
dirt.
c) If it is very dirty, the motor protection filter should be
rinsed.
The filter must then be left to dry for at least 24
hours.
46
d)After cleaning, refit the motor protection filter into
Replacing the exhaust filter
Vacuum cleaner with micro-hygiene filter
This should be replaced with every replacement filter
pack
Figure
a)Release the filter holder by moving the locking lever
b)Remove the micro-hygiene filter.
c) The micro-hygiene filter can be rinsed out.
d)Remove the micro-hygiene filter. Insert the new
e)Insert the filter holder into the appliance and lock it
Vacuum cleaner with HEPA filter
If your vacuum cleaner is equipped with a HEPA filter,
this must be replaced once a year.
Figure
a)Unlock the HEPA filter by moving the locking lever in
b)Insert the new HEPA filter and lock it in place.
After vacuuming fine dust particles, clean the motor
protection filter and, if necessary, replace the
microhygiene filter or HEPA filter.
Care
Always switch off the vacuum cleaner and disconnect it
from the mains before cleaning the vacuum cleaner. The
vacuum cleaner and plastic accessories can be cleaned
with ordinary plastic cleaner.
!
If required, the dust compartment can be vacuumed out
with a second vacuum cleaner or simply with a dry
duster/ dusting brush.
Figure 20
Subject to technical modifications.
* depending on model
the appliance, lock it in place and close the dust bag
compartment lid.
23*
Open the dust bag compartment lid.
in the direction of the arrow.
The filter must then be left to dry for at least 24
hours.
micro-hygiene filter into the appliance.
in place.
24*
Open the dust bag compartment lid.
the direction of the arrow and remove the filter from
the appliance.
Do not use abrasive materials, glass-cleaning agents
or all-purpose cleaning products. Never immerse the
vacuum cleaner in water.
Figure 20
20
Figure