Care And Maintenance; User Groups; Filter Change - Weller MG100S Traduction De La Notice Originale

GB
ENGLISH
Fire and explosion hazard!
WARNING
The unit is not permitted to be used for
The organisation operating the unit is responsible for the
the place of work.
in perfect working order.
Intended use of the soldering station/ desoldering
applicable at the place of use.
The manufacturer will not be liable for unauthorised

User groups

Work step
connected
Replacing electrical repla-
cement parts
nance intervals
Operation

Filter change

Operation
Notice
portation. Make sure that the unit is put into service in
a suitable room.
CAUTION
cause the activated charcoal to heat
Put the tool into operation as described in the chapter
Please adhere to the operating instructions of the
connected devices.
on the nameplate.
16
Find Quality Products Online at:
User groups
Specialist personnel with
technical training
Technical trainees under the
guidance and supervision of
Electricians
Technical trainees under the
guidance and supervision of
-
Non-specialists
GlobalTestSupply
www.
Make sure the machine is switched off before plugging
in.
achieved with larger molecules)

Care and maintenance

WARNING
Before doing any work on the ma-
chine, pull the plug out of the socket.
Repairs must always be referred to a Weller-trained
specialist.
-
Filter change
The normal service life of a main
MIN 1x
1500 hours.
year
ensure proper gas separation.
An alarm s
alarm with the reset function on the control panel and
An alarm sounds and the red warning light is lit
continuously:
changed.
-
minutes in order to avoid overheating.
reset as follows:
turn on the switch until a signal sounds.
Cleaning
on a regular basis.
.com
sales@GlobalTestSupply.com