Inflation - Gong FREEWAVE 12,9 Guide De L'utilisateur

KITE INFLATION
1 - Unfold the Kite, back towards wind, in a debris
free area that's nonabrasive or jagged, Extrado
on the ground, with the Leading Edge close to
you and perpendicular with the axis of the wind.
4 - Tightly close the low section of the Inflation Valve.
7 - Disconnect the Pump Tube.
8 - Close the Valve and cover with neoprene
protector.
EN
2 - Open the clips for the ONE-PUMP System for
strut inflation off one valve.
3 - Verify the Bridles.
5 - Unscrew the top section of the Valve and insert
the Pump Tube.
6 - Inflate the Kite between 8-10 PSI. DO NOT Over
Inflate the Kite.
9 - Close the ONE-PUMP System clips on all the
Struts.
10 - Take the Pump Leash off while holding the Kite
so it does not get picked up by the wind.
11 - Turn the Kite over, Intrado facing the ground,
Leading Edge facing the wind and use the sand
for anchoring the Kite.
- 16