High Power Mode; Setting The 1 Hour Timer - AirBlue Uline 13 DCI Notice D'utilisation

HIGH POWER MODE

You can select High Power only during cooling mode and
not during dehumidifying (dry) and fan mode. High Power
mode allows to obtain the maximum air conditioner's
efficiency. The user can choose to activate the High Power
mode, using the remote control unit, after having selected
cooling mode. Under these conditions the air conditioner will
reach its maximum thermal power and consequently also
the maximum electrical consumption and noise. On the
contrary, if you want to obtain the best performance in
efficiency and silentness, High Power mode is not
EG
recommended: let the air conditioner run in normal condition
(factory default program).
To activate High Power mode it is necessary (after having
selected the cooling mode) to press the HIGH POWER
button : the symbol
the operation lamp (green lamp on the front panel of the air
conditioner) begins blinking slowly, indicating that High
Power mode is activated; press the button again to release
the function: therefore the green lamp will stop blinking and
it will be switched on permanently.
NOTES
During the high power operation the room temperature
l
could not correspond to the set temperature.
HIGH POWER program remains set also if you switch
l
OFF and ON again the air conditioner.
switches on; at this point
SETTING THE TIMER
A) HOW TO SET THE ON TIME
1. Press the ST button once.
The ON and time indications flash.
2. Press the H button until the designed
hour is displayed.
Press the M button until the designed
minutes are displayed. The display will
change automatically back to show the
present time after 10 sec.
3. Press the ON/OFF button to start the air
conditioner.
4. Press the button to activate the ON
timer.
B) HOW TO SET THE OFF TIME
1. Press the ST button twice.
The OFF and time indications flash.
2. Press the H button until the designed
hour is displayed.
Press the M button until the designed
minutes are displayed. The display will
change automatically back to show the
present time after 10 sec.
3. Press the ON/OFF button to start the air
conditioner.
4. Press the button two times to
activate the OFF timer.
C) HOW TO SET A PROGRAM FOR
DAILY ON/OFF OPERATION (OR
VICEVERSA)
1. Set the timer ON/OFF as shown in A)
and B).
2. Press the ON/OFF button to start the air
conditioner.
3. Press three times the
activate the DAILY timer.
NOTE
After timer setting, press ST button in order to check the
ON/OFF setting time.

SETTING THE 1 HOUR TIMER

This function causes the unit to operate for one hour at the
set conditions, regardless of whether the unit is on or off.
TIMER SETTING PROCEDURE.
Press four times the
l
HOUR TIMER mark will appear on the
display.
CANCELLATION PROCEDURE
Press the ON/OFF button to turn the air conditioner off.
l
Wait for the indoor unit to stop operating.
l
Press the ON/OFF button again to turn the air conditioner
l
on.
9
C
3
2 2
1 4
button to
button.The 1