Programming For Automatic Watering - Parkside HG04678 Instructions D'utilisation Et Consignes De Sécurité

Remark: In case you input a wrong data, you can always
press the (ON/OFF) button

Programming for automatic watering

1. Switch on the product. Press the SET button
2 seconds.
The program number display flash on the "Prog"
section will flash on screen (see Fig. 5).
2. Use the rotary button to set the program number (e. g.
Prog 3) and confirm by pressing the SET button
The hour display on the "Start" section will flash on
screen (see Fig. 6).
3. Set the hours for starting the watering time with the rotary
control
5
The minute display on the "Start" section will flash on
screen (see Fig. 7).
4. Set the minutes for starting the watering time with the
rotary control
SET button
The hour display on the "Run Time" section will flash
on screen (see Fig. 8).
5. Set the hour for the watering time and confirm with the
SET button
(e. g. 6 hours) and confirm with the SET button
(e. g. 20 minutes) and confirm with the
5
.
4
.
4
to go to previous step.
7
for approx.
4
.
4
.
4
GB/IE 61