Audio Settings - Panasonic TY-FB11DHD Mode D'emploi

● Audio Settings
By installing this terminal board in a compatible display, its audio settings can be performed by the display.
(For details on the display method, setting method, etc., see the instruction manual for the display unit.)
In the Sound menu of the Display
SDI Sound Output
Left Channel
Right Channel
Sound Out
Level Meter
Level meter display
1ch 9ch
2ch 10ch
3ch 11ch
4ch 12ch
1-8ch 9-16ch
Notes:
• Audio signal output will be suspended if signals other than listed under "Audio signals supported by this board"
have been input.
• Audio output will be suspended if a channel which is not one of the multiple channels among the SDI signals has
been selected.
* Output will be suspended if either output channel (L/R) is selected.
• As described above, of the audio input by this board, only multiplexed audio of the HD-SDI/Link A input signal is
output.
● SDI Through Selection
This board includes a through output (active through) function, allowing output on the display to be turned ON/OFF.
(For details on the display method, setting method, etc., see the instruction manual for the display unit.)
On the display's Setup - Signal menu
Signal
Cinema reality
SDI Through
Refresh Rate
Noise reduction
Note:
• Set this setting to "Off" when not using through output. If this setting remains set to "On", the potential transmission
distance may be reduced.
12
Left Channel:
2/2
Channel 1
Channel 2
Right Channel: Selects the SDI audio channels whose signals are to
On
Off
Sound Out:
Level Meter:
0 dBFS
-20 dBFS (0 dB)
Shown above is a screen display for 1-8ch
and 9-16ch.
SDI Through
［Digital］
Off: Stops through output. (Default setting)
On: Enables through output.
Off
Off
100 Hz
Off
Selects the SDI audio channels whose signals are to
be output to the left channel of the display.
Channel 1 to channel 16
(Initial setting: Channel 1)
be output to the right channel of the display.
Channel 1 to channel 16
(Initial setting: Channel 2)
Sets the SDI audio output on or off
(initial setting: On).
Displays the SDI audio level meter.
Off, channels 1 to 8 (1-8ch), channels 9 to 16 (9-16ch)
(Initial setting: Off)
5ch
6ch
7ch
8ch
1-8ch
13ch
14ch
15ch
16ch
9-16ch