Proper Use; Technical Data - Indexa DF20K Mode D'emploi

Operating instructions
GB
1. Introduction
Read through these operating instructions fully and carefully. The operating
instructions belong to this product and contain important points concerning
bringing the appliance into service and ist operation. Also read the operating
instructions of the basic set.
Always pay attention to all safety instructions. Should you have any questions
or be unsure about operating the appliance ask a specialist. Keep these
instructions in a safe place and should the need arise pass them on to a third
party.

2. Proper use

The digital wireless camera set consists of the camera DF20K and the mains
adaptor.The additional camera is an optional accessory for DF25 Set, DF25A
Set, DF15 Set and DF15A Set. It is to be used for the surveillance of rooms,
entrance hallways, driveways etc. through video pictures and sound. The
video and audio transmission is wireless using a frequency of 2.4GHz.
The power for the DF20K is supplied through the supplied mains adapter
connected to a 230VAC, 50Hz mains supply.
If there is sufficient light a colour picture will be transmitted. At low ambient
light levels the integrated Infrared LEDs are automatically switched on. In this
case the immediate area (max. 3 m) will be illuminated and the video picture
switches to black and white mode for improved light sensitivity. Due to the
sensitivity to infrared light some colours may vary on the camera picture. If the
surveillance is specifically required in a dark environment, then additional
lighting should be installed.
Up to four wireless cameras DF20KA can be used with one monitor. The camera
channels can be manually selected or automatically displayed in sequence if
the scan mode is selected. The camera pictures can also be observed
simultaneously in quad-split screen mode.
The wireless transmission is digital and on constantly changing frequencies
(frequency hopping) which are synchronised between the camera and the
monitor. Only the receiver which has been "paired" with the camera can receive
the synchronised signals. This security feature prevents access of the camera
signal by third parties.
The camera is weatherproof (Protection class IP66) and can be used not only
indoors but also for mounting outside. Wherever possible it should be protected
from direct rainfall. The receiver and both mains adapters are for indoor use
only and must be protected from moisture. The set is for use in private
households. A video surveillance system does not replace your duty of care or
supervision. Observe the regulations concerning video surveillance in
commercial and public areas.
Any other use or modification of the device is not authorised. No liability will be
accepted for consequential damages or for damages caused by improper use or
incorrect operation. No liability will be accepted for consequential damages
caused by any function or by malfunction. Unless any liability is specifically
required by law, claims for damages, in particular those for personal injury or
property damage caused by non-functioning or malfunctioning of the machine,
are excluded.
12 - GB
This appliance is not intended to be used by people (including children) with
restricted physical, sensory or mental capacities, or a lack of experience and/or
knowledge, unless they are supervised by, or receive instructions how to use the
appliance from a person responsible for their safety.
3. Package contents
!
DF20K camera with connection cable to mains adapter
!
Antenna
!
Mains adapter 5VDC
!
Camera bracket with screws and plugs
!
User manual
4. Features and Equipment
1 Camera
2 Power LED
3 Infrared LEDs
4 Connection-LED
5 Triangular nut
6 Wing screw
7 Bracket
8 Microphone
9 Antenna connection
10 Pairing button
11 Mains adapter connection
12 Mains adapter
13 Lens
14 Daylight sensor
15 Antenna
16 Plugs
17 Screws

5. Technical data

Camera DF20K
Operating Voltage
Current consumption
Channels
Picture sensor
Viewing angle
Light sensitivity
Illumination
Illumination distance
Microphone
Protection class
Dimensions without antenna (mm) 92 x Ø 42
Operating temperature
Mains Adapter
Operating Voltage
Output
(s. fig. A)
(s. fig. A)
"
5 V DC (mains adapter)
340 mA
4
1/10" CMOS
approx. 39° horizontal
1-8 Lux (w/o IR-LEDs)
9 Infrared LEDs
max. 3 m
built in
IP 66
- 10° C to + 40° C
230 V ~ 50 Hz
"
5 V , 1,0 A