TFK TWIN adventure Notice D'utilisation page 9

Instruction manual and assembly instruction
- (fig. I)
In order to be able to use the Twin Adventure, at first always unfold
the lower part of the frame. With the hand or the foot you press the
basket frame (1) laterally to the left and to the right, until it engages
audibly. This is very important for the stability.
- (fig. II)
Afterwards swivel the push bar (2) upwards, until the red double
safety device (3) engages. Now close the black bolting devices (4)
on the left and on the right side above the folding joint.
- (fig. III)
Put the covers on the left and on the right into the mounting plates
(5) at the middle push bar (2). Then slide them in the mounting plate
at the left and right push bar. Afterwards it will be fixed with a zipper
and a Velcro® fastener on the left and the right side and finally
fasten it with press buttons at the backrest.
- (fig. IV)
During the initial assembly of the rear wheels, you first put the brake
calliper (7) on the brake disk (8). Then you insert the axle (9) into the
wheel hub and then into the specified drilling of the rear axle, until it
engages.
- (fig. V)
Afterwards you hang the brake cable (10) into the admission at the
central brake cylinder (11) and control the function of the brake
through operate the hand brake lever (19) at the handle bar (2). If
you like to remove the wheels, loosen the brake cable (10) from the
brake cylinder (11) and press the TFK button (9) in the centre of the
wheel. Now you can take the wheels off.
- (fig. VI)
Put the front wheel (12) into the provided opening until it audibly
engages. On position 1 the front wheel (12) can turn freely and on
position 2 it is fixed. If you press the red button (13), you can remove
the wheel downwards.