Installation; General Information; Electrical Installation; Installing The Microwave - AEG MSB2547D Notice D'utilisation

3. INSTALLATION

WARNING!
Refer to Safety chapters.

3.1 General Information

CAUTION!
Do not connect the
appliance to adapters or
extension leads. This can
cause overloading and risk
of fire.
CAUTION!
The minimum installation
height is 85 cm.
• The microwave is for built-in use only.
It must be placed on a stable and flat
surface.
• The cabinet can not have a back wall
in the place where the microwave is
located.
• Put the microwave far away from
steam, hot air and water splashes.
• If the microwave is too close to a
radio or TV set it may cause
interference in the received signal.
• If you transport the microwave in the
cold weather, do not activate it
immediately after the installation. Let
is stand in the room temperature and
absorb the heat.

3.2 Electrical installation

This microwave is supplied with a main
cable and main plug.
The cable has an earth wire with an
earthing plug. The plug must be plugged
into an outlet that is properly installed
and earthed. In the event of an electrical
short circuit, earthing reduces the risk of
electric shock.

3.3 Installing the microwave

1. Check if the dimensions of the
furniture meet the installation
distances.
C
D
A
B
Installation distances
Dimension
A
B
C
D
2. If the cabinet depth is over 300 mm,
put the template on the bottom of
cabinet and check if it fits. If yes,
mark the spots for screws. Remove
the template and fix the bracket with
the screws in the marked spot.
Skip this step if the
cabinet depth is 300
mm.
=
ENGLISH 43
mm
380 + 2
560 + 8
500
45
=