Before You Begin - Radiodetection RD5100S Guide D'utilisation

Before you begin

IMPORTANT
This guide is intended to be a quick reference guide. We recommend you read the full
operation manual before you attempt to operate the RD5100S locator.
First use
The RD5100S locator can be powered by D-cell alkaline batteries,
D-cell NiMH batteries, or by an accessory Lithium-Ion (Li-Ion) battery pack.
To fit the D cell batteries in the locator, open the battery compartment and insert two
D-Cell Alkaline or NiMH batteries, taking care to align the positive (+) and negative (-)
terminals as indicated.
Rechargeable battery packs
Lithium-Ion battery packs are available for the locator, providing superior performance
over traditional alkaline batteries. To fit these rechargeable packs, follow the
instructions provided with each pack.
Checking the system software version and last
calibration date
To check which version of software is running on your locator and the date of the last
calibration, press and hold the key when switching the locator on. This information
may be asked for when contacting Radiodetection or your local representative for
technical support.
System setup
Regional and operational requirements are factory configured, no set-up is required.
7