Duux Slim 1000 Manuel D'utilisation page 6

Hour setting
The current hour can be set by pressing the timer
button, which shows the number 23 and the
symbol will blink on display. The time can be set
by pressing and , after which the display will
show the different hours from 00 to 23. When the
hour setting is completed, press the timer setting
button to enter the minute settings. The display will
keep blinking for 7s if no button is pressed.
Minute setting
After finishing the hour setting, the program will
automatically enter into minute setting and the
number 30 and on the display will flash. The
correct minute can be set by pressing and
, after which the display will show the different
minutes from 01 to 59. When the minute setting
is completed, press the button to complete the
time setting and to enter normal mode. The display
will keep blinking for 7s if no button is pressed.
Note: If no buttons are pressed for 7 seconds
then the product will go back to its setting. Only
when the correct hour and minute have been
confirmed, will the different operation modes
function accordingly.
10
Remote control
Note: This heater is equipped with a remote
control, which can be used in the same way as the
control panel on the side of the product.
First remove the insulating paper which covers
battery before using the remote control. Follow
below instructions:
Remove the battery bracket from back of
1
remote control like figure A.
Remove the insulating paper that covered
2
battery like figure B.
Insert the battery bracket into remote control
3
like figure C.
B C
A
Note: Please use this remote control within 6
meters distance, please make sure the control angle
is within 30 degrees.
Normal operating mode
In the normal operating mode the temperature
can be adjusted according to the preferred
temperature by pressing or button. The
product can be used with a temperature will range
of 15°C to 36°C.
Timer setting
The product can automatically shut down by using
the timer function. When the product is turned on,
press the button for 3 seconds to activate the
timer shut down function. The display will show 00
and . The time can be set by pressing and ,
after which the display will show the different hours
from 00 to 23. For example; 02 means that the
product will automatically shut down after 2 hours.
The product can also automatically turn on by
using the timer function. When the product is
in standby mode, press the button to set the
desired timer and follow to same steps as with the
timer shutdown.
Note: If you switch to other modes (HOME/
OFFICE/CABIN), the timer setting will be cleared
automatically.
Heating mode setting
This heater is also equipped with 3 intelligent
modes called HOME, OFFICE and CABIN. The
different modes can be activated by pressing
button.
Note: Current date and time need to be set
before using the intelligent heating modes. Please set
the time according above Date/Hour/Minute setting
steps.
Home mode setting
The default high temperature value is set at 23°C
and low temperature at 18°C.
Note: There are 4 periods (P1,P2,P3,P4) in this
mode:
P1: 08:00-16:00 18°C
P2: 16:00-23:00 23°C
P3: 23:00-06:00 18°C
P4: 06:00-08:00 23°C
The pre-set temperature will follow the same
cycle every day. The desired temperature can be
adjusted at all times but will return to the default
value in next cycle. For example; the current time
is 9:00 and the desired temperature is set to 20°C.
The temperature will stay in 20°C from 9:00 to
16:00 and will return back to 18°C the next day.
11