Master/Slave Mode; Dmx Mode - Velleman HQ POWER VDPL710MHW14B Mode D'emploi

Inverse Pan and Tilt Movement
You can inverse the direction of the pan and/or tilt movement:
1. Press <MODE/ESC> until <PAN> or <TILT> is displayed and press <ENTER>.
2. Use <UP> and <DOWN> to select the desired setting:
o <Yes>: for pan or tilt in the inverse direction.
o <No>: for pan or tilt in the normal direction.
3. Press <ENTER> to confirm.
7.4

Master/Slave Mode

The master/slave mode allows connecting several devices to a single master device. All slave devices will
then work synchronously with the master device.
You need to set one device to master mode and all other devices to slave mode. The first unit in the
chain functions as the master device.
1. Connect all devices in series with DMX cables.
2. On the master device, press <MODE/ESC> until <SLND> is displayed and press <ENTER>.
3. Use <UP> and <DOWN> to choose <MAST> and press <ENTER>.
4. Set the program as described in Stand-Alone Mode.
5. On each slave device, press <MODE/ESC> until <SLND> is displayed and press <ENTER>.
6. Use <UP> and <DOWN> to choose the desired setting:
o <SL1>: to run in normal slave mode.
o <SL2>: to run in inverse slave mode.
7. Press <ENTER> to confirm.
7.5

DMX Mode

This mode allows you to control the fixture by any universal DMX controller.
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
In case of the 7-channel mode, you will have to set the start address of the first unit to 1 (CH1-7),
the second to 8 (1 + 7) (CH8-14), the third to 15 (8 + 7) (CH15-21), and so on. The highest start
address is 506.
In case of the 12-channel mode, you will have to set the start address of the first unit to 1 (CH1-12),
the second to 13 (1 + 12) (CH13-24), the third to 25 (13 + 12) (CH25-36), and so on. The highest
start address is 501.
To set the device to work with a DMX controller:
1. Press <MODE/ESC> until <CHND> is displayed and press <ENTER>.
2. Use <UP> and <DOWN> to select the 7 or 12 channel DMX mode and press <ENTER>.
3. Press <MODE/ESC> until <Addr> is displayed and press <ENTER>.
4. Use <UP> and <DOWN> to set the DMX starting address (A001–A512) and press <ENTER>.
DMX Channel Values
7 channel mode:
Channel From
1
2
3
11
4
V. 01 – 26/03/2013
VDPL710MHW14B/VDPL710MHW14W
To
0 0
1 255
0 0
1 255
0 10
255
0 0
1 255
Description
Stop
Pan position
Stop
Tilt position
Close
Master dimmer, brightness from dark to bright
Close
Red, brightness from dark to bright
7 ©Velleman nv