Before First Use - Fritel FryTasTic 5150 Mode D'emploi

2. BEFORE FIRST USE

 Remove all packaging and stickers.
 Keep all packing material out of reach of children.
 Check that there is no damage to the deep fryer or the power cord. If there is any damage, do
NOT use the deep fryer and return it to the sales point.
 Before using the deep fryer for the first time, clean the bowl and the basket (see point 4.3).
 Disassemble the deep fryer in this order: basket – control panel with heating element – bowl.
 Clean the bowl and the basket
 Assemble the deep fryer in this order: bowl – control panel with heating element – basket.
 Always put the bowl in the housing in such a way that the suspension hook (10) is at the front
of the deep fryer.
 Check if the sliders (4) fit precisely in the grooves (2) made for that purpose (backside control
panel).
 Ensure that the voltage marked on the rating-plate is the same as your main voltage.
3. USE OF THE FRYTASTIC FRYER
3.1 The first use
3.1.1. Use of frying oil
1. Remove the lid and the basket
2. Fill the deep fryer with oil between the MIN and MAX inside the bowl (17).
Caution: NEVER switch on/warm up the deep fryer WITHOUT oil or with UNSUFICIENT
oil. If you do so, the deep fryer may get damaged permanently. NEVER leave water in the
stainless steel bowl when filling it with oil or fat. The oil must always be between MIN and
MAX, otherwise the safety thermostat switches off. Only use oil suitable for frying/for high
temperature.
3. Then follow the instructions from 3.2 point 1.
3.1.2. Use of solid fat
With this program the frying fat is melted as per special electronic procedure, determined in
advance, in a safe and controlled way.
1. Remove the lid and the basket.
2. Cut the fat in small pieces and spread over the complete heating element (fig.F).
3. Completely unroll the power cord and insert the plug into the socket.
4. Push the thermostat knob for 2 sec. (fig. A). On the display the text « Turbo SF System
Activated » and a sound signal will be heard.
5. On the display following text will flash « Melting Solid Fat » (14).
6. Push the thermostat knob to confirm (fig. C). The red lamp (fig.D) lights up and the fat will
start melting.
Caution: if you do NOT push the thermostat knob within the 15 sec. the display will return to
the previous setting. (In this case: Turbo SF System Activated)
23