Franke FMA605BK Mode D'emploi Et Installation page 6

Fitting the hood body
• Open the doors/the door (See section Open Panels).
• Remove the Metal grease filters using the handles
provided.
• Adjust the two screws Vr, in the brackets 11a, so that
they are at the start of their travel.
• Hook the hood body to the two brackets 11a.
• From the inside of the hood body, turn screws Vr to
level the hood body itself.
• Fasten the safety screw 12a.
• Close the doors/the door again.
Air outlet – Recirculation Version
• Screw the filter cover onto the air outlet, using four
screws 12c (2.9 x 6.5).
• Fix the directional Grid 8 on the recycled air outlet,
using 2 screws 12d (2.9 x 9.5) provided.
• Open the Door/Doors (See paragraph Opening
Panels).
• Remove the Metal grease filters using the handles
provided.
• Make sure that the Activated charcoal odour filter
has been fitted.
AIR OUTLET - DUCTING VERSION
To install the hood in the ducting version, please refer
to the instructions provided in the ducting kit specific to
the hood.
EN
Connections
12a
12d
8
12c
16
11a
Vr
6 6