Rotating Base - Heta Scan-Line 900 Mode D'emploi

These guidelines contain instructions for fitting wood-
burning stoves on the Scan-Line rotating base. Please
read these instructions thoroughly before positioning the
rotating base on the floor, so as to make sure that you
complete the installation process correctly.
The rotating base makes it possible to turn the stove
face in the direction of your choice. Depending on the
fitting option chosen, the stove can be turned steples-
sly through 120º or 180º. If the stove is installed free-
standing and away from combustible material, 360º free
rotation is also an option.
NB: Direct supply of combustion air through the floor is
not possible when the stove is positioned on a rotating
base.
The rotating base is designed for the Scan-Line range.
Safety distance
Do not place any combustible material, furniture or fittings
within the safety distance indicated. Please note that the
safety distance varies according to the installation option
chosen and the angle of rotation applied. Place the rota-
ting base on the floor and check the safety distance when
the turning plate is rotated.
Floor plate
Remember to take the rotation of the stove into account
when calculating the size of the floor plate – refer to the
instructions for the use of your stove. No matter what the
type of flooring, the surface must be flat and level.
Safety regulations
The owner is personally responsible for complying with
the obligatory safety requirements, and for ensuring that
the installation is checked by a responsible inspector.
Please pay special attention to the fact that strong heat
is radiated through the glass door. If combustible mate-
rial is placed closer to the stove than the safety distance
stated, this may lead to unintentional combustion. Please
refer to the instructions for the use of your stove. See Fi-
gure 1 – example of safety distance to combustible walls
for a Scan-Line 500 stove.
Combustible wall
Safety area
60°
60°
0°
1230
Figure 1
Degree of rotation 180°
Pivot centre
The pivot centre of the stove is centred through the rota-
tion spigot directly into the centre of rotation of the rota-
EN
Degree of rotation 120°
Combustible wall
Safety area
90°
90°
0°
1230
ting base. The rotating base is factory set to turn 180º, i.e.
to turn 90º to each side.
Figure 2
Pivot centre
for stove and
chimney.
Centre
screw
Rotating
base
Changing the turning angle
If the stop screw is removed, the rotating base can turn
through 360º. See Fig. 2.
If you wish to reduce the angle of turn to 120º, remove the
stop screw and invert the rotating base. See Fig. 3.
Turn the base plate to 120º. The arrow points directly at
the hole for the stop screw. Turn the rotating base once
more, and fit the stop screw.
Figure 3
Fig. 3
End stop
120°
6
Rotation spigot
Stop screw
180°
Base plate