Table des Matières
Publicité
Fig. 14
26
m Maintenance
Warning: In the interests of operational safety, always switch
off the saw and remove the mains plug before carrying out
maintenance work.
General
Re-application of the wax coating on the workbench
makes feeding the workpiece to the blade easier.
Motor
The mains cable should be replaced immediately if
pulled out, cut or damaged in any other way.
Do not lubricate the motor bearings or internal parts!
Saw arm bearings
Lubricate the saw arm bearings every 50 hours. Proceed
as follows (Fig. 14).
•
Turn the saw to the side
•
Apply a generous amount of SAE 20 oil to the shaft
end and bronze bearings.
•
Let the lubricant oil work in overnight.
•
Repeat the procedure the next day on the other side
of the saw.
eC Declaration of Conformity
We herewith declare, Woodster GmbH, Günzburger Str. 69, D-89335
Ichenhausen that the machine described below due to its con struc-
tion and design and in the version delivered by us complies with the
relevant provisions of the following EC Directives.
In case of a modification of the machine this declara tion ceases to
be valid.
Machine description:
Scroll Saw
Machine type:
sd 16f, Art.-Nr. 390 1402 911, 390 1402 908, 390 1402 000
Relevant EC directives:
eC machine directive 2006/42/eG,
eC low voltage directive 2006/95/eWG,
eC-eMV directive 2004/108/eWG.
Notified body within the meaning of Annex VII
TÜV Rheinland, Sicherheit und umweltschutz GmbH, 51101 köln
Place, date:
Ichenhausen, 15.10.2009
Signature:
on behalf of Wolfgang Windrich (technical director)
Publicité
Table des Matières
