Transferring Patients In And Out Of Bed; Cpr (Cardio Pulmonary Resuscitation) - Gaymar Plexus Auto Aire Select Manuel D'emploi

Auto Aire Select™
Check patient at least every 8 hours or, once per shift, to assure
proper system inflation. Otherwise, desired therapy may not occur.
10.2.3 To prevent accidental changes in settings, press the LOCKOUT button.
10.3 AP Mode
10.3.1 If alternating low pressure therapy is also desired press the AP button. Alternation will occur every 2
minutes and 30 seconds.
10.3.2 Pressing the AP button again causes the control unit to exit the AP mode.
11.0

Transferring Patients In and Out of Bed

11.1 For patient transfer press the MAX INFLATE button. This will maximally inflate the mattress to provide a
firm and stable support surface (and suspend AP and automatic modes). Pressing the MAX INFLATE
button again will cancel this mode and return the mattress to previously chosen settings.
11.2 While in the max inflate mode, the indicator within the MAX INFLATE button will flash to remind the
caregiver that the system is in this state. After approximately 30 minutes, the control unit will automatically
cancel the max inflate mode and return to the previously chosen settings.
12.0

CPR (Cardio Pulmonary Resuscitation)

To deflate mattress for CPR:
12.1 Disconnect the dual quick-connect couplings of the mattress hose from the control unit. Mattress will
deflate in approximately 20 seconds.
12.2 Proceed with CPR procedures.
WARNING
9