Elica Salice Série Guide D'utilisation, D'entretien Et D'installation page 18

Grease filter saturation alarm (Optional)
After thirty fan functional hours, the display w ill show
"Grease Filter " if the fan is active.
When this icon is shown in the display, the grease filters
installed are required to be washed.
To reset the grease filter saturation alarm the user must
press the "+" button for 5 seconds, after this acti on the
icon "Grease filter " is not displayed, and the hood has
the normal display operation.
Charcoal filter saturation alarm (Optional)
After one hundred and twenty functional hours of the fan,
the display will show " Charcoal Filter " if the fan is active.
When this icon flashes on display, the charcoal fil t ers
installed are required to be replaced or reactivate d.
To reset the charcoal filter saturation indicati on the user
must press the "-" button for 5 seconds, after this time
the icon " Charcoal filter " is not displayed and the hood
has the normal display operation.
Audible signal activation and deactivation
The audible signals can be activated or deactiva ted
pressing the " Light " button for 5 seconds.
If the audible signal is activated, a tone must sound and
the "Snd " symbol must appear on the display for 3
seconds.
If the audible signal is deactivated, the " Snd " symbol
must appear on the display for 3 seconds and no ton e
must sound.
Charcoal filter inclusion and exclusion (Recirculat ing
accessories)
The charcoal filter inclusion or exclusion can b e set by
pressing the "+" and "-" buttons at the same time f or 5
seconds.
The Inclusion or exclusion of charcoal filter mu st be
selected while the lamps and the motor are OFF.
When the charcoal filter has been excluded, the charcoal
filter alarm is disabled.
Heat sensor
The control is equipped with a heat sensor that will turn
on the blower at third speed if excessive heat occu rs
(over 149° F or 65°C ) surrounding the control area.
If the blower is OFF or if it is operating at fi rst speed, the
blower will be set automatically to third speed, th e
display shows the word " CArE " to indicate that heat
sensor has detected an excessive heat.
During this state, the user may raise the blower speed to
fourth speed but can not decrease the speed.
When the temperature level on the hood drops to n ormal,
the blower will operate in the setting defined by t he user
before the alarm occured.
18