Frigidaire GLSZ28V8CB4 Guide D'utilisation Et D'entretien page 4

To prepare for removing the doors:
Make sure the electrical power cord is unplugged from the wall
1
outlet.
Open both doors and remove the toe grille.
2
Remove any food from the door shelves.
3
Close the doors.
4
To remove the top hinge cover(s):
Depending on your model, follow the appropriate procedure below.
Large Hinge Cover
Remove the three screws from the cover over the top door
1
hinges.
Pull the cover forward and lift it off.
2
Small Hinge Covers
Remove the cover screw and cover from the top hinge of both
refrigerator doors.
To remove the refrigerator door:
Trace lightly around the door's top hinge with a pencil. This
1
makes reinstallation easier.
Remove the two screws from the top hinge. Lift the door off of the
2
bottom hinge and set it aside.
Remove the three bottom hinge screws and hinge, if necessary.
3
To reinstall the refrigerator door, reverse the above steps. Once
both doors are in place, also replace the top hinge cover.
To remove the freezer door:
Detach the multi-wire cable connector located above the top
1
hinge. Grasp both sides of the connector firmly and pull apart.
Trace lightly around the door's top hinge with a pencil. This
2
makes reinstallation easier.
Detach the water tube from the connector located below the
3
freezer door. The connector releases when you press its outer
sleeve inward.
Remove the screws from the top hinge. Leave the multi-wire
4
cable inside the hinge. Do not unscrew the ground wire that
attaches the cable to the hinge. Lift the door off of the bottom
hinge.
Remove the three bottom hinge screws and hinge if necessary.
5
Lay the door on its side to avoid damage to the water tube
6
extending from the bottom hinge.
To reinstall the freezer door, reverse the above steps. Once both
doors are in place, also replace the top hinge cover.
4