TFK T-44 Notice D'utilisation page 9

Operating- and assembly instruction
Assembly of the carrycot
- (pic.I) Remove the mattress and swing the two clamps (1) till
the stop of the part (2) , which is fixed at the bottom of the
carrycot.
- (pic.II) Close the pushbuttons (5) left, right and at the head
end from the outside. To close the canopy, push the red
buttons (6) and swing it back.
- (pic.III) Place the foot cover (7) over the carrycot and close
the pushbuttons (8) left and right.
- (pic.IV) Put the included mosquito net (9) over the canopy
frame while the canopy is opened and close the pushbuttons
(8) left and right. Therefore it is necessary to open the
pushbuttons of the canopy, then close the ones of the
mosquito net and fix the pushbuttons of the canopy on top of
them. Finally stretch the mosquito net over the foot end of the
carrycot frame.
Assembly of the different carrycot tubes
1. Use with one carrycot
- (pic.V) If you want to use the Twin with a newborn baby and
a child from 9 months, which is already able to sit, you can fix a
single carrycot only on the left side of the frame (in driving
direction)! Remove the seat cover, belly frame and the
canopy on the left (Please have a look to the instruction of the
Twin).
- (pic.VI) First fix the small belly frame on the right seat. Bring it
to the right position and lock the clip (10) around the frame
tube.
- (pic.VII) Stick the front carrycot tube (11) next to the
pushbutton over the frame tube in the middle and after that
swing it over the left frame tube next to the pushbutton. Close
the bar (12), it will secure the carrycot tube.