Tools Needed; Assembly - Ryobi GD200 Manuel D'utilisation

The following tools (not included or drawn to scale) are needed for assembly and adjustments:
6 or 7 Foot
A-Frame Ladder
UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the loose parts
list are included.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts on the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-877-205-5714 for assistance.

TOOLS NEEDED

Flat Head
3/16 in.
Screwdriver
Drill Bit
Phillips Head
Socket Bit (10,
Screwdriver
11, and 13 mm)
Socket Wrench
(10, 11, and 13 mm)
Drill
Tape Measure

ASSEMBLY

Level
Adjustable
Wrench
Wire
Stripper
Pliers
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
15 - English
Rubber
Mallet
Hammer
Pencil
Hacksaw
2 x 4 board (1 ft.)
Fig. 7