Installation Requirements; Tools And Parts; Location Requirements - Whirlpool WOD51ES4EW Instructions D'installation

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
P hillips screwdriver
■
M easuring tape
■
L evel
■
Parts Needed
U L-listed or CSA-approved conduit connector
■
U L-listed wire connectors
■
Parts Supplied
F our # 8-14 x 1" screws
■
R ight and left side trim
■
B ottom vent (supplied on some models)
■
B ottom vent trim
■
T wo # 8-18 x ³⁄ " screws – bottom vent
■
8
Check local codes. Check existing electrical supply.
See "Electrical Requirements."
It is recommended that all electrical connections be made
by a licensed, qualified electrical installer.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.
C abinet opening dimensions that are shown must be used.
■
Given dimensions provide minimum clearance with oven.
R ecessed installation area must provide complete
■
enclosure around the recessed portion of the oven.
G rounded electrical supply is required. See "Electrical
■
Requirements" section.
E lectrical supply junction box should be located 3"
■
(7.6 cm) maximum below the support surface when the
oven is installed in a wall cabinet. A 1" (2.5 cm) minimum
diameter hole should have been drilled in right rear or the
left rear corner of the support surface to pass the appliance
cable through to the junction box.
NOTE: For undercounter installation, it is recommended
that the junction box be located in the adjacent right or
left cabinet. If you are installing the junction box on rear
wall behind oven, the junction box must be recessed and
located in the upper or lower right or left corner of the
cabinet; otherwise, the oven will not fit into the cabinet
opening.
O ven support surface must be solid, level, and flush with
■
bottom of cabinet cutout. Floor must be able to support
a single oven weight of 140 lbs (63.5 kg) or a double oven
weight of 245 lbs (111.1 kg).
Undercounter Installation (with cooktop installed above):
Ovens approved for this type of installation have an approval
label located on the top of the oven. Refer to undercounter
installation instructions for cutout dimensions and approved
oven cooktop combinations (separate sheet).
2

INSTALLATION REQUIREMENTS

H and or electric drill (for
■
wall cabinet installations)
1 " (25 mm) drill bit (for wall
■
cabinet installations)
Product Dimensions – Single Oven
E
D
A. 22³⁄ " (56.8 cm) max. recessed width
8
B. 29" (73.7 cm) max. overall height
C. 23³⁄ " (60.3 cm) overall width
4
D. 23" (58.4 cm) max. recessed depth
E. 27¹⁄ " (69.9 cm) recessed height
2
Cabinet Dimensions – Single Oven
Single Oven Undercounter (without cooktop installed above)
E
A. 24" (61 cm) min. cabinet width
B. 1¹⁄ " (3.8 cm) min. top of cutout
2
to underside of countertop
C. 5¹⁄ " (13.3 cm) bottom of cutout to floor
4
D. 22 ⁄ " (57.5 cm) cutout width
5
8
E. 27³⁄ " (70.5 cm) min. cutout height
4
A
B
C
B
A
D
C