Periods Of Non-Operation; What To Do If - ZANKER KBF11401SK Notice D'utilisation

3. Leave the door
open and insert
the plastic scra-
per in the appro-
priate seating at
the bottom cen-
tre, placing a ba-
sin underneath
to collect the de-
frost water
In order to speed up the defrosting process, place
a pot of warm water in the freezer compartment.
In addition, remove pieces of ice that break away be-
fore defrosting is complete.
4. When defrosting is completed, dry the interior
thoroughly and keep the scraper for future use.
5. Switch on the appliance.
6. After two or three hours, reload the previously re-
moved food into the compartment.
Warning! Never use sharp metal tools to scrape
off frost from the evaporator as you could damage
it.

What to do if...

Warning! Before troubleshooting, disconnect the
mains plug from the mains socket.
Problem
The appliance does not oper-
ate. The Pilot light does not
flash.
The Pilot light flashes.
The Alarm light flashes.
The compressor operates
continually.
18
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The appliance is not working proper-
ly.
The temperature in the freezer is too
high.
The temperature is not set correctly.
The door is not closed correctly.
Do not use a mechanical device or any artificial means
to speed up the thawing process other than those
recommended by the manufacturer.
A temperature rise of the frozen food packs, during
defrosting, may shorten their safe storage life.

Periods of non-operation

When the appliance is not in use for long periods, take
the following precautions:
• disconnect the appliance from electricity supply
• remove all food
• defrost (if foreseen) and clean the appliance and all
accessories
• leave the door/doors ajar to prevent unpleasant
smells.
If the cabinet will be kept on, ask somebody to check it
once in a while to prevent the food inside from spoiling
in case of a power failure.
Only a qualified electrician or competent person must
do the troubleshooting that is not in this manual.
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Contact a qualified electrician.
Refer to "Excessive Temperature
Alarm"
Set a higher temperature.
Refer to "Closing the door".
Solution