Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Unpack the Overhead Gearloft™
Storage Rack
1. Unpack the rack sections, support sections, ceiling brackets
and all hardware. Verify contents. See "Parts".
2. Dispose of all packaging materials properly.
Tools and Parts
Install overhead Gear loft storage rack according to
■
manufacturer's instructions and any local codes.
Only use provided fasteners. Do not use an alternate form of
■
mounting. Do not alter or modify any components included
with this product.
Gather the required tools and parts before starting assembly.
■
Read entire manual before starting assembly.
■
WARNING
Excessive Weight Hazard
Use two or more people to move storage rack.
Failure to do so can result in back or other injury.
Tools Needed
Electric drill
■
Drill bit (3/16") - Included
■
1/2" Socket wrench and/or 1/2" open end wrench
■
6 mm Allen wrench - Included
■
Stud Finder (If ceiling has drywall covering joists/rafters)
■
Tape measure
■
Step stool or step ladder
■
Pencil / Marker
■
Masking Tape
■
ASSEMBLY INSTRUCTIONS
1. Intended for garage use, installed into a wood framed/
2. To be used for storing light-weight items overhead and out of
3. Recommended to be positioned 6'- 8" minimum above floor
4. Check for clearance of all doors, vehicles, or any items to be
5. The maximum weight of all items combined on the rack not to
Overhead Gearloft™ Storage
Rack Use Requirements
traditional wood structure type dwelling.
the way.
(standard door opening height)
positioned under the storage rack.
exceed 750 lbs.
5
Publicité
Table des Matières
