Heavy Duty Rack Geartrack Installation Instructions; Tools And Parts; Heavy Duty Rack Geartrack Pack Use Requirements; Unpack - Gladiator GAGP24WRHY Instructions D'installation

HEAVY DUTY RACK GEARTRACK

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Phillips Head Screwdriver
■
Drill and 3/32" drill bit
■
Parts Supplied
2 screws
■
INSTALL THE HEAVY DUTY RACK GEARTRACK
1.
Hand brackets in desired position
Put Left and Right Hand brackets in desired position on
■
the end of your 24" (60.9 cm) or 18" (45.7 cm) deep rack.
(use the following # for rack models - GARS774XEG,
GARS604TEG, GARS484TEG)
2b.
Install GearTrack
(for model 18")
GearTrack Channel is provided at 24" (60.9 cm) length, but can
®
be cut to size for the 18" (45.7 cm) deep rack. If necessary, cut
the channel to length, making sure the cut is square.
06-Feb-2019 12:25:10 EST | RELEASED
INSTALLATION INSTRUCTIONS
Channels
®
18"
In some European factories the letter "W" of the part code mentioned herein will be automatically
Heavy Duty Rack GearTrack
Pack Use Requirements
Maximum weight limit is 75 lbs (34 Kg) per linear ft (30.48 cm)
■
for Rack GearTrack Channels.
®
Do not use the hanging cabinets or wall GearBoxes on the
■
Rack GearTrack ® . This GearTrack
hook with a maximum claim load of 50lbs.

Unpack

Remove all parts from their packaging, and dispose of/recycle
■
all packaging materials.
2a.
Install GearTrack
(for model 24")
Install GearTrack Channels into the side of one bracket and
®
■
then sliding through to other bracket.
Ensure that the ends of the GearTrack
■
with the ends of the rack.
3.
Install Ends Caps
Install provided end caps on each side of the GearTrack
■
Channel.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
PACK
®
® is only intended for any
PACK
®
Channels
®
Channels are level
®
®
®
5