Troubleshooting - ECOVACS WINBOT 7 Mode D'emploi

No. Malfunction
Remote Control
1
does not work.
Status Indicator Light
does not flash BLUE
2
after WINBOT 7 is
placed on the glass.
Possible Causes
WINBOT 7 is cleaning.
When WINBOT 7 is
cleaning, only the START/
PAUSE Button works on
the Remote Control.
The batteries in the Remote
Control are not installed or
need to be replaced.
The Remote Control is not
paired with WINBOT 7.
WINBOT 7 arrives from
the factory paired with
its Remote Control. If the
Remote Control becomes
un-paired or is replaced, it
can be re-paired.
There is not enough suction
to attach WINBOT 7 to the
glass.

6. Troubleshooting

Solutions
Pause WINBOT 7 by pressing
the START/PAUSE Button on the
robot or the Remote Control. Other
buttons on the Remote Control will
function when WINBOT 7 is paused.
Install batteries or replace with new
batteries.
Power ON WINBOT 7. At the same
time, press and hold
WINBOT 7 and the Pairing Button
on the Remote Control. Paring is
complete when WINBOT 7 beeps.
A. Check Cleaning Pads to ensure
proper placement. Remove the
Cleaning Pads and re-attach them
making sure they are placed exactly
within their Velcro areas on WINBOT 7.
B. Check for debris on the Cupule.
Clean the surface of the Cupule
with the provided Finishing Cloth as
described in section 4.
C. Check for accumulated dust or
debris on the glass where WINBOT 7
is placed. Clean a small area on the
glass before use and place WINBOT 7
there.
D. Press WINBOT 7 on the window
a little more firmly.
button on
15 15
EN EN