Additional Safety Instructions For Glue Guns; Operation; Before Use; Using The Appliance - Parkside PHP 500 E3 Traduction Des Instructions D'origine

the appliance . Cleaning and user
maintenance tasks may not be car-
ried out by children unless they are
supervised .
■ To avoid potential risks, damaged mains cables
should be replaced by the manufacturer, their
customer service department or a similarly
qualified person .
Additional safety instructions for
glue guns
■ Children should be supervised to ensure that
they do not play with the appliance .
■ CAUTION! This appliance must be placed on
its stand when not in use .
■ Always protect the appliance from rain and
moisture . Water entering a power tool will
increase the risk of electric shock .
■ Do not misuse the power cord, e .g . to carry
or hang up the appliance, or to pull the plug
from the socket . Keep cord away from heat,
oil, sharp edges or moving parts . If the power
cord is damaged or severed during work, do
not touch the cord but rather pull out the power
plug . Damaged or entangled cords increase the
risk of electric shock .
■ Only for indoor use .
■ If you take a break of longer than 30 minutes,
pull out the power plug .
■ Allow the appliance to cool completely after
use and before storage .
■ Do not work on any material containing asbestos .
■ Avoid the risk of injury or fire as well as
health risks: RISK OF BURNS! The
adhesive and the nozzle reach a
200
temperature of around 200°C . Do not touch the
nozzle or the glue . Do not allow hot glue to come
into contact with people or animals . In case of
contact with skin, rinse the affected part in cold
running water for a few minutes . Do not attempt to
remove the adhesive from the skin .
■ Always route the power cable towards the rear,
away from the appliance .
■ Do not pull back the glue stick!
Cut it off to store the device in the
carrying case .
PHP 500 E3

Operation

Before use

Preparing the surfaces to be glued:
■ Do not use flammable solvents to clean the
surfaces to be glued .
■ The ambient temperature and the materials to
be bonded may not be colder than 5°C and
not warmer than 50°C .
■ The area to be glued must be clean, dry and
free of grease .
♦ Smooth surfaces should be roughened before
gluing .
♦ Quick-cooling materials such as steel should be
warmed a little to facilitate adhesion .

Using the appliance

Mains operation:
♦ Connect the power cable
connection of the glue gun
Insert the power plug into the socket .
♦ Fold down the plastic stand
appliance .
♦ Push a glue stick into the feeder shaft
♦ Allow the appliance to heat up for about
5 minutes . The appliance is now ready for use .
Cordless operation:
♦ Connect the power cable
connection of the charger
plug into the socket .
♦ Place the glue gun into the charger
♦ Push a glue stick into the feeder shaft
♦ Allow the appliance to heat up for about
5 minutes . The appliance is now ready for use .
♦ Repeat the heating phase if the glue is still too
thick or viscous .
Gluing:
♦ Pull the trigger to control the flow of glue in
accordance with your requirements .
to the mains
(see fig . A) .
. Put down the
.
to the mains
. Insert the power
.
.
GB │ IE │ 9 ■