Wacom Pen Display Guide D'installation Et D'utilisation page 41

Macintosh-Specific Problems
At startup, a dialog box
appears telling you that
either the driver failed to
load or the tablet
preferences have not yet
been created.
Inkwell does not work
correctly with the pen
display tablet.
The pen display tablet was not detected at startup. Check that the
USB interface cable is securely connected to a USB port on your
computer or to a USB hub. Make sure that the pen display power
LED is on. If this does not correct the problem, see Troubleshooting
on page 29.
From the G menu, select A
O
folder. Launch the A
PPLE
V tab. A USB tablet should be displayed by the profiler.
AND OLUMES
If a USB tablet was not found, check the pen display's USB cable
connection or try plugging the pen display into a different USB port.
If you are still having problems, go to the Applications/Utilities folder,
open the Disk Utility program, and run R
the F A tab. If this does not help, contact Technical
IRST ID
Support. See Technical support options on page 38.
There may be a problem with the Inkwell preferences. Remove the
damaged preference files as follows. They will be recreated when
you enable handwriting recognition.
1. From the Apple menu, choose S
System Preferences menu, choose S
Then turn off handwriting recognition.
2. From the G menu, choose your H
O
P folders. Then remove the following preferences:
REFERENCES
• com.apple.ink.framework.plist
• com.apple.ink.inkpad.plist
• com.apple.ink.inkpad.sketch
3. Go back to S
YSTEM
handwriting recognition.
4. Test the Inkwell function using your pen display tablet
and pen.
5. If this procedure does not resolve your problem with Inkwell,
contact Apple Support for further assistance. Is not the
software manufacturer for Inkwell and we are limited in our
abilities to support a third party software application.
and open the U
PPLICATIONS
S P and select the D
YSTEM ROFILER
EPAIR
P
YSTEM
HOW
. Open the L
OME
P and I
REFERENCES NK
TILITIES
EVICES
D P from
ISK ERMISSIONS
. From the
REFERENCES
A and select I .
LL NK
and
IBRARY
, and then enable
Troubleshooting
page 37