Whirlpool W10385100B Instructions Pour L'installation page 6

Installation Clearances
For each arrangement, consider allowing more space for ease
of installation and servicing; spacing for companion appliances
and clearances for walls, doors, and floor moldings. Space
must be large enough to allow door to fully open. Add spacing
on all sides of dryer to reduce noise transfer. If a closet door
or louvered door is installed, top and bottom air openings
in door are required.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.
NOTE: No other fuel-burning appliance can be installed in the
same closet as a dryer.
Installation spacing for recessed area
or closet installation
All dimensions show recommended and minimum spacing
allowed.
■
Additional spacing should be considered for ease of
installation and servicing.
■
Additional clearances might be required for wall, door, floor
moldings, dryer venting, and gas line.
■
Additional spacing should be considered on all sides
of the dryer to reduce noise transfer.
■
For closet installation, with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are
acceptable.
■
Companion appliance spacing should also be considered.
Recommended installation clearances:
Closet installation (dryer only):
34" recommended
(864 mm)
5"
(127 mm)
1"
(25 mm)
6
3"
(76 mm)
48 in.
(310 cm
18" min.
(457 mm)
24 in.
(155 cm
3"
(76 mm)
1"
(25 mm)
Closet Installation (stacked washer and dryer):
5"
(127 mm)
(25 mm)
Cabinet installation (dryer only):
7"
(178 mm)
2
5"
2 )
(127 mm)
2
2 )
Custom under counter installation (dryer only):
(25 mm)
6"
(152 mm)
(76 mm)
76"
(1930 mm)
(76 mm)
1"
1"
(25 mm)
1"
(25 mm)
1"
(25 mm)
1"
3"
48 in. 2
(310 cm )
2
24 in.
2
(155 cm )
2
3"
18"
(460 mm)
1"
(25 mm)
39" min.
(990 mm)