Makita GA7031 Manuel D'instruction page 6

1
010784
Loosen the lever on the wheel guard. Mount the wheel
guard with the protrusion on the wheel guard band
aligned with the notch on the bearing box. Then rotate
the wheel guard around to the position shown in the
figure. Tighten the lever to fasten the wheel guard. If the
lever is too tight or too loose to fasten the wheel guard,
loosen or tighten the nut by spanner to adjust the
tightening of the wheel guard band.
To remove wheel guard, follow the installation procedure
in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc (accessory)
WARNING:
Always use supplied guard when depressed center
•
grinding wheel/Multi-disc is on tool. Wheel can
shatter during use and guard helps to reduce
chances of personal injury.
1
2
3
010788
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
with its protrusion facing downward (facing toward the
wheel).
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
2
010345
1. Nut
2
2. Lever
1. Lock nut
2. Depressed
center grinding
wheel/Multi-disc
3. Inner flange
1. Lock nut wrench
2. Shaft lock
To remove the wheel, follow the installation procedure in
reverse.
NOTE:
In countries other than United States and Canada,
•
Inner flange 45 can be also used.
Installing or removing flex wheel (optional
accessory)
WARNING:
Always use supplied guard when flex wheel is on
•
tool. Wheel can shatter during use and guard helps
to reduce chances of personal injury.
1
2
3
4
010999
Follow instructions for depressed center grinding
wheel/Multi-disc but also use plastic pad over wheel. See
order of assembly on accessories page in this manual.
NOTE:
In countries other than United States and Canada,
•
Inner flange 45 can be also used.
Installing or removing abrasive disc (optional
accessory)
NOTE:
Use sander accessories specified in this manual.
•
These must be purchased separately.
1
2
3
010998
Mount the rubber pad onto the spindle. Fit the disc on the
rubber pad and screw the lock nut onto the spindle. To
tighten the lock nut, press the shaft lock firmly so that the
spindle cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
6
1. Lock nut
2. Flex wheel
3. Plastic pad
4. Inner flange
1. Lock nut
2. Abrasive disc
3. Rubber pad