Dometic PERFECTVIEW Switch 300 Notice D'utilisation page 12

Connecting the control box
The circuit diagram for the control box can be found in fig. 6, page 5:
Pos. Connection name
rt/sw Red/black cable: connection to the two-pin switch
sw Black cable: Connection to earth (terminal 31)
ws White cable:
• Connection to the control cable of the three-pin switch for the right-hand
• Connection to the two-pin switch
gr Grey cable: Connection to the control line of the three-pin switch for the reverse
camera (connection to switch plug L)
rt Red cable: Connection to +12 V to +24 V (e. g. switched positive, terminal 15)
bl Blue cable: Connection to the monitor control line (standby/monitor on)
gn Green cable: Connection to the right indicator
br Brown cable: Connection to the left indicator light
ge Yellow cable: Connection to the control wire of the three-pin switch for the left
camera (connection to switch plug B)
or Orange cable: Connection to the reversing light
1 Camera connection 1
2 Camera connection 2
3 Camera connection 3
4a Output for reversing monitor (RCA)
4b Output for reversing monitor (DIN)
I
NOTE
SWITCH300 matches different reversing video components to each other, but no
video standards. For this reason camera and monitor must match (PAL with PAL and
NTSC with NTSC). Most LCD monitors support both standards.
12
camera (connection to R switch-plug)
SWITCH300
EN