Replacing The Filters - Franke F3SM2004 Notice De Montage Et De Mise En Service

14.8 Pull the bottom of the cover plate (f) forwards and detach at the top.
Install the cover plate
14.9 Insert the cover plate (f) into the frame tabs at the top and fit.
14.10 Push on the rosette (g).
14.11 Fasten the cover plate at the bottom, using the screws (e).
14.12 Check the flow time and adjust where necessary (see
14.13 Check the temperature and set the temperature stop if necessary (see
☞
Important!
When putting the pressure cap in place, ensure that the tappet engages with the
corresponding groove.
14.14 Fit the spring (a) and pressure cap (b).
14.15 Secure the pressure cap with the locking ring (c).
14.16 Fit the small cover plate (d).

15. Replacing the filters

15.1 Remove the cover plate (see
15.2 Remove the tap (a).
15.3 Replace the filter seals (b).
☞
Important!
Note the installation position of the filter seals.
15.4 Mount the tap (a).
15.5 Mount the cover plate (see
Chapter 14.).
Chapter 14.).
- 8 -
Chapter 12.).
Chapter 13.).